The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old September 5, 2005, 12:03 PM   #1
kingudaroad
Senior Member
 
Join Date: March 11, 2005
Location: austin
Posts: 735
working up a load

I'm working up a hunting load for 44 mag. I've worked up 5 different powder weights. To find the most accurate load and to compensate for my own mistakes I've been measuring the best 7 out of 10 shots to measure my groupings. Is this a fair way to do this or are there better methods.
kingudaroad is offline  
Old September 5, 2005, 08:52 PM   #2
smedley
Member
 
Join Date: June 21, 2005
Location: NW washington with property in E. Washington
Posts: 43
Are you able to call your "mistakes?" If so then measure the ones that are "clean" shots. It's those 3 out of the ten that you need to make sure are not because of the load, flyers, and are actually booboos. I usually shoot 3 5-round groups of the same load to get a better feel for the best accuracy. It takes more time and of course more money but it works best for me.
Sometimes a different primer will pull in a group. A tighter crimp can make a difference too.
There is another thread going on with "pet" 44mag loads that may help you out too.


Smedley


Pop em in at the bench and blast em out down the tube
smedley is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:37 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05633 seconds with 9 queries