The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 17, 1999, 09:36 PM   #1
keepgf
Junior Member
 
Join Date: March 17, 1999
Location: Newport News Va USA
Posts: 2
I have a gunsmith frame in .38 super. Does anyone know if the 38 super mags will take 9mm reliably. Any advice in this endeavour to build a decent 9mm para?
thanks
keepgf is offline  
Old March 17, 1999, 10:43 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Keep, no the .38 Super mags are too long. If you were building a 9x23 they'd work. I suggest you go to www.m1911.org . Click on the block titled Technical issues. There is step by step instructions for building a 1911 located there. It's really very good. George
George Stringer is offline  
Old March 17, 1999, 10:51 PM   #3
Daniel Watters
Senior Member
 
Join Date: February 7, 1999
Location: USA
Posts: 644
Para-Ordnance shows a 9x19mm model on their web page, the P18-9. Perhaps they have done something different with their magazines in order to make it work. It would be worth an e-mail or phone call to check it out.

www.paraord.com

[This message has been edited by Daniel Watters (edited March 17, 1999).]
Daniel Watters is offline  
Old March 18, 1999, 03:53 AM   #4
Ken Cook
Senior Member
 
Join Date: March 4, 1999
Location: Hot Springs AR. USA
Posts: 265
George is right. Can't be done with 9x19 in .38 super mags. However, it CAN be done with the frame. Just for your peace of mind, check with them to ensure that the 9x19 mags will fit in your frame. (They should, but I can't say for certain. Haven't handled a PARA frame in about 6 years.)
9x23 would be really cool though!

------------------
Your mind is your primary weapon.
Ken Cook is offline  
Old March 18, 1999, 11:29 AM   #5
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,131
Colt 9mm P mags have a block at the rear, and the lips are shaped differently from the .38 Super mag. The frames are the same and the .38 ejector should work OK. Note that the slide has to be 9mm, though. The .38 is semi-rimmed and the extractor won't fit quite right for 9mm. Of course all of this can be overcome with money and time. BUT, with all the 9mms out there, is building one worth it?
James K is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:57 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06756 seconds with 9 queries