The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old August 8, 2005, 12:55 AM   #1
Sierra_Nevada
Junior Member
 
Join Date: August 8, 2005
Posts: 4
Dixie gun works hawken kit problem

this is my first black powder rifle. it is a dixie gun works hawken kit (cap lock). i am trying to install the barrel. i have attached a barrel rib to the bottom of the barrel (supports cleaning rod). when i try to install the barrel assembly it does not fit. when i try to seat the barrel the rib rests on top of the brass nose cap instead of in front of it stopping the barrel. supposedly this kit is all inletted and ready to go. it seems that the rib is too long. the barrel sits fine if the rib is off. anyone tried this kit, had this type of problem, or any suggestions? i sent an e-mail to dixie tonight also. the rifle is just about ready to go. its just the rib holding me back!

thx!
Sierra_Nevada is offline  
Old August 8, 2005, 07:59 AM   #2
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 17,057
Kits are rarely in their entirety "drop-in." You may have to fit it a bit by relieving the stock. Some folks use inletting black (available commercially) which is an oily composition that has black soot (so I think) mixed in. It is applied to the part to be fitted and when the part is fitted against the wood, leaves the black mark on the area of the wood to be removed. I tend to use the black tip marker for the same purpose.

Never having worked on a half-stock gun (or examined enough of them), I can't tell you how far the rib goes into the stock. For asethetics though, I would think that it should appear flush.
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is offline  
Old August 8, 2005, 11:46 PM   #3
arcticap
Senior Member
 
Join Date: March 15, 2005
Location: Central Connecticut
Posts: 2,973
Shorten the rib?

If the rib is sitting on the brass nose cap, it sounds like the rib is too long and needs to be shortened a bit, yes? Can that be done without losing any
retaining screws? I hope so.
arcticap is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:41 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05724 seconds with 9 queries