The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Thread Tools Search this Thread
Old January 23, 2000, 06:17 PM   #1
Senior Member
Join Date: November 4, 1999
Location: Alachua, FL., USA
Posts: 236
Just received my M/D holster, belt and mag pouch in the mail last Tuesday. The belt is 1 1/2" in width and although it fit the holster like a glove, the ammo pouch was about 1/2" too narrow. So what did I have to do? Before I knew what I was doing, I took out my trusty knife and cut a slit along the top and bottom of the notch and "wholla" the belt fit through nice and snug. Now the problem, how do I keep the "slit" from increasing in size? I was thinking about getting a leather punch and putting in a stitch, any suggestions?

CrociJA is offline  
Old January 23, 2000, 06:54 PM   #2
Bud Helms
Join Date: December 31, 1999
Location: Middle Georgia
Posts: 13,078

Try punching a nice clean hole centered exactly over the end of the cuts you made.
Bud Helms is offline  
Old January 24, 2000, 09:19 AM   #3
Mark THG
Join Date: October 13, 1998
Location: The Woodlands, Texas
Posts: 83
You could have contacted ma and I would have taken care of it ASAP. In fact if it's a problem just drop me a line and I'll still take care of it.

M/D ENTERPRISES Custom Concealment Holsters
Gunleather so nice it's almost a crime to conceal it

Mark THG is offline  
Old January 24, 2000, 05:02 PM   #4
Senior Member
Join Date: November 4, 1999
Location: Alachua, FL., USA
Posts: 236
Hehehe...Now that's what I call customer service. What are the chances? I just may take you up on your offer Mark. However, the LF-1 class is in another month, so I might just want to hang on to it until then.
Going to the range next weekend, and I want to have the entire rig to get used to it.

CrociJA is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:58 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04656 seconds with 9 queries