The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old December 14, 1999, 01:51 PM   #1
WinMag
Member
 
Join Date: November 12, 1999
Posts: 49
My Millet rings came with what looks like hard rubber shims with an adhesive backing. It almost looks like they would fit inside the rings. I have a 10/22T with a 6-24x44AO, and need to shim my scope to raise my point of impact. If I put one of these on the rear ring only (inside), would it cause undue stress on the scope body when I tighten it down since the front one does not have one? Or are these things designed to go in the rings (both front and back) to protect the scope body from scratches...etc? OR, are these things designed to go under the scope base between the reciever?

Thanks,
WinMag
WinMag is offline  
Old December 17, 1999, 02:56 PM   #2
CMOS
Senior Member
 
Join Date: June 10, 1999
Location: TEXAS
Posts: 1,417
Well, I'll tell you what I did with mine.

I believe these "pads" are to be placed on both the top and bottom half of the inside of each ring to act as a "gasket" to make up for any imperfections on the inside of the rings themselves. As you can see, the pads are also *slightly* rough which will also help to secure the scope body in the rings while deterring movement.

I have 2 scopes with mounts done this way. They are still rock solid.

CMOS
CMOS is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:35 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06133 seconds with 9 queries