The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old March 31, 1999, 12:06 PM   #1
Tom B
Senior Member
 
Join Date: February 16, 1999
Location: GA
Posts: 1,836
After reading about and experiencing myself problems with the Glock 19 ten round magazines with flat follower I called Glock today. Problem is last round in mag will jam on barrel ramp. Glock said they were aware of problem and would send me free replacement curved followers.
Tom B is offline  
Old March 31, 1999, 01:36 PM   #2
Rob Pincus
Senior Member
 
Join Date: October 9, 1998
Location: Hotels
Posts: 3,679
There are a ton of known problems in various Glocks with older Followers. Everyone should check to make sure that they have newer ones.

I think the .40 cal followers are up to generation 5, with unmarked and #2's being seriously prone to not locking the slide back.

------------------
-Essayons
Rob Pincus is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:20 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05449 seconds with 9 queries