The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old August 26, 2000, 08:29 PM   #1
cnemeth
Senior Member
 
Join Date: June 30, 1999
Location: East Stroudsburg, PA
Posts: 171
I've read that many people that compete in CAS polish the chambers of their guns to make reloading quicker.
I shot my new Ruger .357 Blackhawk on Friday. The chambers appeared to be "tight" since it had to pull the spent cases out. In only one chamber did the case fell out with just the use of the ejecter rod.
How do you polish the chamber in a firearm?

Thanks
chris Nemeth
cnemeth is offline  
Old August 27, 2000, 08:11 AM   #2
Bill Mitchell
Staff Alumnus
 
Join Date: October 15, 1998
Location: Roswell,GA
Posts: 433
Howdy,

Brownells sells honing brushes and oil made just for revolver chambers. I've neard of folks using brake hones and even sandpaper wrapped around a dowel,but usin a tool specially designed for the job is a better choice.

Bellicose Bill
Bill Mitchell is offline  
Old August 29, 2000, 06:40 AM   #3
Ned Roundtree
Senior Member
 
Join Date: December 8, 1999
Location: Lexington, KY,USA
Posts: 738
I think most times folks mention polishing chambers they are talking about their side x side shotguns. Smoother chambers makes it easier to "chuck" shot shell. Their are some pistol reloading stages. But most times folks are talking about polishing their shotgun chambers. My two centavos.
Ned Roundtree is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:31 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05845 seconds with 9 queries