The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old May 5, 2005, 07:54 PM   #1
brasszz
Junior Member
 
Join Date: April 29, 2005
Posts: 14
Tar Removal

I bought some indian .308 surplus ammo a few years ago before I found out it was junk. When I found out how crappy the ammo was I stopped shooting it and I 've had it laying around ever since. I am in the process of pulling the ammo down so I can make some use out of it, but I'm not sure what the best way of getting out the tar used to seal the bullets. I thought of using paint thinner, denatured alcohol, or acetone. Will any of these work or is there a better way?
brasszz is offline  
Old May 5, 2005, 09:20 PM   #2
Bob41081
Member
 
Join Date: June 4, 2004
Location: Houston,Tx
Posts: 45
Tar removal

Any of those should work. WD-40 should also work. If you arenot interestred in saving the powder or primers a 50/50 solution of Dawn soap and water should also work and would be alot safer although it will reguire a little more elbow grease. A few yrs ago I was doing some experiments to test Rig Washes, using a 17.5 ppg Oil mud. On a lark I tried a 1% Dawn solution and it was as good as any of the rig wash samples.

Bob
Bob41081 is offline  
Old May 5, 2005, 09:20 PM   #3
Mark whiz
Senior Member
 
Join Date: May 19, 2004
Location: Wabash, IN
Posts: 227
I've used paint thinner & mineral spirits before to clean up pulled surplus bullets - worked real well. I then tumbled them to give a good final cleaning & polish to them.
__________________
"Every moving thing that liveth, I give unto you as meat" (Gen 9:3)
Aim small.........miss small.
Trust God..........but keep your powder dry
!
Mark whiz is offline  
Old May 5, 2005, 09:21 PM   #4
sundog
Senior Member
 
Join Date: November 22, 1999
Location: Green Country, OK
Posts: 730
Ed's Red, and then throw it in the tumbler? sundog
__________________
safety first
sundog is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:30 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07262 seconds with 9 queries