The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 8, 2005, 03:44 PM   #1
Trip20
Senior Member
 
Join Date: March 21, 2005
Location: WI
Posts: 2,181
Brass and Aluminum?

Question about those CCI Blazers... I bought 50 in .45acp but I had a choice between the aluminum cased or brass cased (same specs other than casing) and I chose the brass but it was a few bucks more expensive.

Is there any point in me using the brass over the aluminum if I don't reload? As in, aluminum is worse for internals than brass?...etc.

Thanks.
Trip20 is offline  
Old April 8, 2005, 09:23 PM   #2
JoeHatley
Senior Member
 
Join Date: July 1, 1999
Location: Iowa
Posts: 2,135
The aluminum cased Blazers are just fine, and usually quite accurate. Since you dont reload, save yourself a few bucks and go alloy.

Joe
__________________
Go NRA
JoeHatley is offline  
Old April 9, 2005, 01:00 PM   #3
Trip20
Senior Member
 
Join Date: March 21, 2005
Location: WI
Posts: 2,181
Thanks for the response Joe.

I'm sorry if I posted this in the wrong forum (assuming this is why I didn't get any responses), but I figured reloaders would be able to answer this question...
Trip20 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:27 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05875 seconds with 9 queries