The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 22, 2004, 10:05 AM   #1
deadeyedick
Member
 
Join Date: October 3, 2004
Posts: 16
Primers for 44 Mag Loads

Hi Everyone!

First let me say thanks for all your great advice, it is much appreciated. I recently received a bunch of primers. There are Remington 2 1/2, Federal 150 LP and CCI 350. I reload 44 mag and have seen the call for different primers in different load data. My question is does it matter which primer to use? Should you use a certain primer with a certain powder or does it only matter that they are for a large pistol or magnum?
I have heard good and bad about all of the above. Please set the story straight.

Thanks!!!!!
deadeyedick is offline  
Old October 22, 2004, 10:39 AM   #2
Edward429451
Junior member
 
Join Date: November 12, 2000
Location: Colorado Springs, Colorado
Posts: 9,494
The straight of the story is...Which one works best in your gun? And if you've worked up a load with a certain (anything) primer, and then switch to a different one, reduce the load and work it back up.

I started with CCI's and gravitated through WW and finally to Federal primers, fwiw.
Edward429451 is offline  
Old October 24, 2004, 05:48 AM   #3
WESHOOT2
Senior Member
 
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,270
UseEmAllBoy

I have found Federal primers easier for 'tuned' revolvers to ignite.

My most accurate loads currently use CCI.

I KNOW that primers make a difference, both in pressure and accuracy, so I experiment.

I use magnum primers for certain loads that normally do not call for them, but I make sure I am well below maximum charge weight.

When using maximum-load 'ball' powders (W296 / AA9 / H110 / etc) I use magnum primers.
__________________
.
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:39 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06254 seconds with 9 queries