The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old December 13, 2002, 03:55 PM   #1
Atc1man
Junior member
 
Join Date: January 2, 2002
Location: Salt Lake City, Ut
Posts: 422
Trimming a barrel down

Is it legal to cut a shotgun barrel down? If so, whats the accepted length and how is it measured?
Atc1man is offline  
Old December 13, 2002, 07:37 PM   #2
Preacherman
Senior Member
 
Join Date: July 9, 2002
Posts: 791
Yes, it's legal, provided that the barrel is not less than 18" in length. (I normally advise going for 18½", so as to leave room for error if the crown is damaged and the barrel needs to be re-crowned.) One normally measures barrel length to include the chamber. Close the action, drop a wooden dowel down the barrel, and make a mark on the dowel at the end of the barrel. Withdraw the dowel, measure the distance between the "breech end" of the dowel and your end-of-barrel mark, and the result is the length of the barrel.
Preacherman is offline  
Old December 13, 2002, 08:11 PM   #3
Atc1man
Junior member
 
Join Date: January 2, 2002
Location: Salt Lake City, Ut
Posts: 422
Thanks. I was thinking 20" would be a good length. My 1300 is primarily a hunting gun, but the 28" barrell is in good condition and unweildy for home use. I was thinking about picking up a used cheap beatup barrel and whacking it down, primarily for home use (backup to my handgun, and barricade weapon)
Atc1man is offline  
Old December 13, 2002, 10:34 PM   #4
psssniper
Senior Member
 
Join Date: October 9, 2001
Posts: 186
Ask Randy Weaver, he may have an opinion or two on this particular question. I'd go 18 1/2" as the Preacherman has suggested but be aware of the "Overall length" rule, (which when violated can get you shot by the alphabets) I believe that may be 26 1/2" but please check it out.
psssniper is offline  
Old December 14, 2002, 12:39 AM   #5
C.R.Sam
Senior Member
 
Join Date: October 29, 1999
Location: Dewey, AZ
Posts: 12,859
By the book.
Shotgun...
Minimum barrel length 18"
Minimum overall length 26"

Either dimension under those and it must be registered as an AOW.

As above stated, be safe and cut a little long.

Sam
C.R.Sam is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:34 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06625 seconds with 9 queries