The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 14, 2002, 03:14 AM   #1
Sidetracker
Senior Member
 
Join Date: September 15, 2001
Location: Rockford, Illinois
Posts: 105
Round nose or flat point for IPSC?

I'm just starting to shoot IPSC and I have noticed many shooters using flat point (JFP) bullets. Is there an advantage to these over round nose (FMJ), especially on the steel targets?
__________________
Those who don't read are no
better off than those who can't.
Sidetracker is offline  
Old October 14, 2002, 07:19 AM   #2
Pampers
Senior Member
 
Join Date: October 7, 2000
Location: In the Lost State of Franklin
Posts: 482
Go with what works.

I've shot FP Truncated Cone bullets for years, but have recently switched to FP Semi-Wadcutters. The SWCs cut a nice sharp hole that makes scoring much easier.

Some guns, however, will only feed round nosed bullets reliably, so use what works in your gun.
__________________
Your Most Humble & Obedient Servant
Fred J. Drumheller
NRA Life
NRA Golden Eagle
Pampers is offline  
Old October 14, 2002, 11:32 AM   #3
stans
Senior Member
 
Join Date: November 9, 2001
Location: Virginia, USA
Posts: 838
I always used lead or plated semi-wadcutters in my 1911 for IPSC. For years I used the 200 grain variety with good results, then went to 255 grain bullets. With the lowered power factor, I think I would go with 200 grain bullets, if I ever get back into IPSC. Round nose bullets will be the most reliable feeders, but it can be difficult to see and score hits on the cardboard targets.
stans is offline  
Old October 15, 2002, 04:47 AM   #4
WESHOOT2
Senior Member
 
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,139
IMNSLE

I shoot R(eliable)N(osed) bullets.
__________________
.
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:23 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06933 seconds with 9 queries