The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old September 9, 2002, 03:06 PM   #1
rocko
Senior Member
 
Join Date: May 27, 2001
Posts: 229
pulled bullets and resizing

Is it absolutely critical that machined pulled bullets be resized? I notice that most suppliers of pulled surplus bullets advertise theirs as being "polished and resized", but I just got a lot of .22 cal tracers from Wideners that I doubt, based on the dirty mess they are, have had anything done to them after being pulled. Would any be deformed so badly during pulling that shooting them as is (well, after cleaning them up, at least) would be dangerous, or just perhaps inaccurate?

Thanks,
Rocko
rocko is offline  
Old September 10, 2002, 01:50 PM   #2
Southla1
Member In Memoriam
 
Join Date: March 19, 2000
Location: Jeanerette, La. Near the
Posts: 1,999
Pulled bullets (if done halfa**** right) should never need sizing. they may have a few dings on them but that does not hurt unless you are trying for sub MOA groups. Most surplus pulled bullets are miltiary and fine for everyday shooting but cannot be depended on for sub MOA groups when new so the few dings wont hurt a bit. Maybe tumble them( or wipe them off if they are tracers) to clean the crud off but thats all thats needed.
Southla1 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05512 seconds with 9 queries