The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old June 28, 2002, 12:07 PM   #1
dntorbert
Member
 
Join Date: July 20, 2001
Location: ALABAMA
Posts: 78
38 s&w (not special)

Just got an old top break running agian and have fired a few factory loads through it from remington and winchester that leaded like crazy. Since it is a top brake will have to keep loads low but thathas never been a problem for me (I have to be careful not to make my 38 special loads to low) but was just wondering if anyone here had experice loading for 38 s&w for the old top breaks . The .360 diam in loading manuals worries me some because will not get enough pressure to obtruate(spl??) to fill groves if use 358. thoughts????
dntorbert is offline  
Old June 28, 2002, 03:39 PM   #2
jjmorgan64
Senior Member
 
Join Date: August 8, 2001
Posts: 519
I fill the case with clear shot BP substitute. This keeps the pressure low, and it is no where near the hastle of true black powder to clean up, standard bullet lubes will work well also.

Of course my Iver is awful old so it doesn't get shot all that often either.
__________________
The Forty-Four spoke and it sent lead and smoke
And seventeen inches of flame. -Marty Robbins

JM
jjmorgan64 is offline  
Old June 28, 2002, 10:30 PM   #3
Mike Irwin
Staff
 
Join Date: April 13, 2000
Location: Northern Virginia
Posts: 35,890
One bullet type kicks ass in these old guns...

Hollow Base Wad Cutters.

The hollow skirt obturates very nicely on firing...
__________________
"The gift which I am sending you is called a dog, and is in fact the most precious and valuable possession of mankind" -Theodorus Gaza

Baby Jesus cries when the fat redneck doesn't have military-grade firepower.
Mike Irwin is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:42 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05999 seconds with 9 queries