Ok I guess it is from the extractor spinning the case and contacting something. I checked some factory cases and they had the mark also.
So then I checked the 2 peices of brass that comes with the gun and they both have the mark. I also looked at some brass fired by my old beretta and it had a mark also but it did not stand out so much with the beretta.
So I guess it must be normal to a degree. It sure looks like it will shorten brass life but I doubt that it will cause a problem if I just don't reload them over say 5 times I guess. I guess a lot of guys just go till the case mouth splits. Is that a safe practice?
I would post a picture but I can't figure it out. It says something about starting an album but I can't find the link it talks about going to. I am not a computer guy.
|