View Single Post
Old December 5, 2012, 04:14 PM   #4
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 321
This happened in a 4 stage progressive press. Station #1 is sizing/priming, #2 is powder/flairing, #3 is seating and #4 is crimping....


As I recall, this happened in Station #3 - bullet seating. So is the the only die I need to carefuly watching and periodically clean when using lead cast bullets?

If you open a package of lead cast bullets and there is too much bullet lube, how do you remove the excess?

thx...
rajbcpa is offline  
 
Page generated in 0.03578 seconds with 8 queries