The Firing Line Forums - View Single Post - Has anyone seen-handled-fired an Alfa Proj .22 revolver?

Renny · November 24, 2011, 02:12 PM

I have this model
http://www.alfa-proj.cz/en/products/...-22-wmr-22-lr/

It's the target model and comes with a grooved barrel for scope mounting.
its very accurate and it has very nice trigger out of the box. I have also handled some of the other models like the Alfa Steel and the Holek, all in 22lr, and they are all very well built and they have better internal and external finish than a Taurus. I would say the quality is at the same level as the CZ rifles.
they come also in other calibers like 357 mag/ 38 special but i have not shot does calibers

Regards
Renny

November 24, 2011, 02:12 PM	#6
Renny Member Join Date: May 16, 2007 Location: Chaco Paraguay Posts: 96	They are very good quality revolvers I have this model http://www.alfa-proj.cz/en/products/...-22-wmr-22-lr/ It's the target model and comes with a grooved barrel for scope mounting. its very accurate and it has very nice trigger out of the box. I have also handled some of the other models like the Alfa Steel and the Holek, all in 22lr, and they are all very well built and they have better internal and external finish than a Taurus. I would say the quality is at the same level as the CZ rifles. they come also in other calibers like 357 mag/ 38 special but i have not shot does calibers Regards Renny