The Firing Line Forums - View Single Post

Dave Sample · June 26, 2005, 01:52 PM

Here is my solution to the problem. This is a Caspian Gold Cup that I rebuilt after another smith replaced the lower end and ruined a stock Colt barrel. It was then a basket case and worthless, so it came to me. I replaced the barrel with a Kart EZ Fit, replaced the trigger group and slide stop, ejector and some other stuff and had the lower end re-finished and added some nice Colt Factory grips to it.

The Millet rear looks good and works good as it has been in service for 18 years with no problem. This gun sold in 23 hours after I put it in the marketplace. I delivered it Friday last.

June 26, 2005, 01:52 PM	#16
Dave Sample Junior member Join Date: December 10, 2004 Location: Prescott, AZ Posts: 1,002	Here is my solution to the problem. This is a Caspian Gold Cup that I rebuilt after another smith replaced the lower end and ruined a stock Colt barrel. It was then a basket case and worthless, so it came to me. I replaced the barrel with a Kart EZ Fit, replaced the trigger group and slide stop, ejector and some other stuff and had the lower end re-finished and added some nice Colt Factory grips to it. The Millet rear looks good and works good as it has been in service for 18 years with no problem. This gun sold in 23 hours after I put it in the marketplace. I delivered it Friday last.