The Firing Line Forums - View Single Post - Lee Auto Disk powder measure

Lost Sheep · June 1, 2011, 06:17 PM

1 Use a thinner shim

2 Get some extra fixed cavity disks, choose a cavity that is slightly too small and ream it out until you get the powder drop you want

I think, before I shaved the adjustable charge bar down, I would ask Lee about the thickness difference.

Thanks for asking our advice and good luck.

Lost Sheep

June 1, 2011, 06:17 PM	#4
Lost Sheep Senior Member Join Date: January 24, 2009 Location: Anchorage Alaska Posts: 3,341	Two other solutions 1 Use a thinner shim 2 Get some extra fixed cavity disks, choose a cavity that is slightly too small and ream it out until you get the powder drop you want I think, before I shaved the adjustable charge bar down, I would ask Lee about the thickness difference. Thanks for asking our advice and good luck. Lost Sheep