View Single Post
Old May 24, 2010, 10:39 AM   #6
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 15,248
Just about anyone with a lathe can make one for you. A gunsmith, a community college student, etc. Measure the diameter of the screw that goes through it, the depth and diameter of the screw head, measure the depth and diameter of the hole it goes into, and give them those dimensions and wait 5 minutes. It's just a metal liner for the hole so the hole won't get wallowed out by the screw.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Scorch is offline  
 
Page generated in 0.02404 seconds with 8 queries