Thread: lube help!!!!!
View Single Post
Old June 11, 2001, 03:48 PM   #8
bfoster
Senior Member
 
Join Date: October 13, 1998
Location: N. of Fords Switch, OK, USA
Posts: 297
The drum in a correctly manufactured powder measure is fitted closely enough to the hole in the main casting so that this problem will not happen until many years have passed. I have an old RCBS uniflow, and a similar Redding measure as well as Dillon & two Harrel measures. This isn't a problem with any of them.

Were I you, I would take this up with the maker of the measure: if it is relatively new, there is a fit up problem, if it is old some of the manufacturers will hone the hole in the casting, then fit a slightly oversize drum at minimal, if any, cost to the consumer.

Bob
bfoster is offline  
 
Page generated in 0.03271 seconds with 8 queries