View Single Post
Old April 17, 2000, 06:00 PM   #2
kframe19
Member
 
Join Date: April 9, 2000
Posts: 61
Your Lee die sets will also crimp your loads.

This is done by making the crimping die part of the bullet seating die.

You screw the die up and down in the press to give you the amount of crimp you want.

The Lee instructions should describe it in a little more detail, but, like just about everything else Lee writes, it isn't the greatest dialog.
kframe19 is offline  
 
Page generated in 0.03964 seconds with 8 queries