The Firing Line Forums - View Single Post - extractor clocking problem

George Stringer · December 24, 1999, 07:16 AM

AA, I can only remember one that the oversize stop didn't cure. I shimmed it and it worked fine. The oversize stop is usually the answer. Epoxy in the rear of the slide won't get warm enough to release. George

December 24, 1999, 07:16 AM	#6
George Stringer Staff Alumnus Join Date: October 12, 1998 Location: Earlington KY Posts: 2,299	AA, I can only remember one that the oversize stop didn't cure. I shimmed it and it worked fine. The oversize stop is usually the answer. Epoxy in the rear of the slide won't get warm enough to release. George