I am only on the periphery of this one Doc.
I too have heard the Star/magantec lub/sizer is the way to go, but I don't own any of the above.
I have had to make a custom sizing die, I am using the Lee sizing die that fits in my single stage reloading press. My Redhawk seems to like cast bullets at about 0.453679". I bought a Lee .452, wrapped some sandpaper around a stick, stuck that in the die as an axle, rolled it back and forth on the bench, ran one bullet through, repeat as needed. Took about four tries, taking off just a little bit at a time, maybe an hour and I am golden now.
Now I buy "as cast" bullets, pan lube them, and then run them through my custom sizer die.
|