View Single Post
Old November 2, 2012, 08:28 PM   #23
browninghunter86
Senior Member
 
Join Date: November 14, 2011
Posts: 524
K&M tool is preset and has a stop to prevent it from going too deep. Just I have no way of determining if I am using it correctly since I never seen one or used on before. K&M cust service told me with their tool you can not push too hard on the case because of its design will only cut the that depth regardless
browninghunter86 is offline  
 
Page generated in 0.02271 seconds with 8 queries