Quote:
To get the cavitys cleaned up cast a few bullets & keep em relative to the cavity from which they came. Next drill an appropriate sized hole for a tap , put the tap in a drill, cover bullet with a comet cleanser/h20 paste & spin em slowly in the cavitys.
It won`t take much so go slow, too much will round sharp corners
The mould will not need smokin after the Leementing process.
|
Only attempt this if you are mechanically inclined. If you are heavy handed, this may not end well. Indication that you are not "mechanically inclined"; if you cannot find the cause of problem by careful inspection.