View Single Post
Old April 1, 2016, 06:31 PM   #3
campingnights
Senior Member
 
Join Date: August 6, 2014
Location: Frozen North
Posts: 272
I kinda doubt that since I also have a Howell conversion cylinder and that lets the cylinder pin seat properly. I am starting to think the gate/firing pin assembly might be drilled offcenter, since the pin seats OK without it? It must be pushing the whole cylinder somehow so the pin wont seat? Not sure at all what is going on.
__________________
Cry HAVOC! and let loose the chihuahuas of war.

My wife told me that I can't have too many guns, I agreed and told her I can never have too many guns...and then the trouble began
campingnights is offline  
 
Page generated in 0.02662 seconds with 8 queries