It appears that I may have the wherewithal shortly to build a 1911 pistol.
In the past I have acquired a 1911 Colt or Springfield and sent it off to Clark, or Best,(now departed, and missed!).
This gun shall be a single stack, long slide (6") ramped barreled, spherical bushed gun in 10mm.
da 10 be da ONE!
So whose frame shall I use? McCormick has good prices and I am told that all the single stack frames are out of the same factory. Is that the case? If not whose from would you recommend?
Long slides, and barrels whose and why?
About 10 years a ago I put an Omega Kit on top of a Springfield frame, but the gun's reliablility never was that great. Incredibly accurate though
!
Help me out here.
Or shall I just go out and buy a Delta Elite and then fit a long slide and 6" barrel to it?
------------------
Ni ellegimit carborundum esse!
Yours In Marksmanship
http://www.1bigred.com/distinguished
michael
[This message has been edited by Michael Carlin (edited 01-31-99).]