Quote:
|
I have one of the moulds that snuffy pictured. It's worth the doghouse. I have to run a little hotter than normal so the boolits drop off the pins easy, as Snuffy indicated.
|
Put just a little dab of 2 cycle synthetic oil on a Q-Tip and when you have your HP pins hot coat them with a very light film of the 2 cycle oil,makes my HP bullets drop right off.
I do this with my NOE RG2 tilt pin HP mold and I can cast a couple hundred HP's before the pins need coating again. I use it to lube my mold as well.
shot as cast in 38 spec. snubby,TL twice and GC left off.
