Thoughts on Reloading and Questions
Just a few thoughts and questions - comments and corrections welcome
Weighing brass is useless unless one has measured OAL of the cartridge and case shoulder
Partial full length resizing often works better than neck sizing unless one sorts necksized brass by measuring the case shoulder
Weighing brass with consistent measurements of the same lot after resizing, trimming, ect... may be useful
Weighing bullets may be useful - but measuring the OAL bullet length and using a bullet comparator to measure length from the base to olgive would make weighing them more useful
Bullet seating depth gauges don't work any better than candling a bullet, chambering it, and then measuring it from the olgive to the casehead
A chronograph really is a necessary piece of equipment
Practical accuracy is different than theoretical accuracy
One can get obsessive compulsive about reloading
|