View Single Post
Old September 15, 2001, 10:08 PM   #6
Jim March
Senior Member
 
Join Date: February 14, 1999
Location: Pittsburg, CA, USA
Posts: 7,417
Joe, that article was VERY interesting...

What I get out of it is thus: since the Wilson fixtures are borderline useless and exact data on doing all this is hard to come by, the $175 or so Power Custom wants for a total replacement hammer/trigger properly made seems a lot more reasonable than it did when I first saw that price. As a bonus, PC will sell you either hammer setup for any Ruger SA.

That's in *addition* to getting an operations drill identical to an SAA if desired and hence easier five-up loading for SASS matches.

I think I'm going to go with a PC hammer/trigger setup instead of paying $115 for a marginal Wilson jig set with almost no instructions.

Finally, I find this a disappointing commentary on Wilson. Their rep is that they build a great 1911, but after-sale service and support is iffy. This is NOT from personal experience, only reading about other's experiences...but this seems to match that "style".
__________________
Jim March
Jim March is offline  
 
Page generated in 0.02395 seconds with 8 queries