The Firing Line Forums - View Single Post

Dave McC · February 15, 2002, 06:08 AM

Recently my second or third hand MEC 600 developed a prob. The Carrier Bar, where the charge bar and the bottles screw into, started to tear where the shot bottle attached. After consulting with some folks over on trapshooters.com, I used JB weld to fix the old one and called MEC for a replacement. They have upgraded the design on the newer ones.

Ordered the part a couple of Mondays ago, it arrived that Friday. Cost was $15, including S&H. Less than 96 hours from the Midwest not bad at all.

Now if they would just work on that auto feed(G)...

February 15, 2002, 06:08 AM	#1
Dave McC Staff In Memoriam Join Date: October 13, 1999 Location: Columbia, Md, USA Posts: 8,811	Mec Service.... Recently my second or third hand MEC 600 developed a prob. The Carrier Bar, where the charge bar and the bottles screw into, started to tear where the shot bottle attached. After consulting with some folks over on trapshooters.com, I used JB weld to fix the old one and called MEC for a replacement. They have upgraded the design on the newer ones. Ordered the part a couple of Mondays ago, it arrived that Friday. Cost was $15, including S&H. Less than 96 hours from the Midwest not bad at all. Now if they would just work on that auto feed(G)...