The Firing Line Forums - View Single Post

taylorce1 · July 22, 2014, 09:49 AM

If it has a matte finish sights and no floor plate of any kind with a synthetic stock it's an ADL model. These were Remington budget rifles in the 90's and early 2000's until the M710 came out and things started going down hill for the budget line rifles for Remington. Up until the recall you could pick up a new M700 ADL with a cheap Remington branded scope for $429 at Walmart, Dick's, or Sportsmans Warehouse around here. The most popular chambers for the ADL was .223 Rem, .243 Win, .270 Win, .308 Win, .30-06, and 7mm Rem Mag.

Get some expanding foam and take the recoil pad off of your stock and fill the butt. Once it cures trim off the excess and re-install your recoil pad. That will remedy you hollow sound of your stock. A lot cheaper than a new stock in the long run.

July 22, 2014, 09:49 AM	#18
taylorce1 Senior Member Join Date: November 18, 2005 Location: On the Santa Fe Trail Posts: 8,249	If it has a matte finish sights and no floor plate of any kind with a synthetic stock it's an ADL model. These were Remington budget rifles in the 90's and early 2000's until the M710 came out and things started going down hill for the budget line rifles for Remington. Up until the recall you could pick up a new M700 ADL with a cheap Remington branded scope for $429 at Walmart, Dick's, or Sportsmans Warehouse around here. The most popular chambers for the ADL was .223 Rem, .243 Win, .270 Win, .308 Win, .30-06, and 7mm Rem Mag. Get some expanding foam and take the recoil pad off of your stock and fill the butt. Once it cures trim off the excess and re-install your recoil pad. That will remedy you hollow sound of your stock. A lot cheaper than a new stock in the long run. __________________ NRA Life Member