The Firing Line Forums - View Single Post

mikld · July 4, 2012, 04:31 PM

"If I am reloading ammunition that requires a post sizing die to chamber it, then I need to learn how to set up my dies correctly and make sure the components are within spec.
I am not a high volume reloader so for me I have no need to post size, but I can see the need for a reloader that cannot check components do to the quantity.
I have been reloading 45acp for over 20 yrs w/o a FCD never had a problem that a FCD would fix."

I agree 100%. I guess I've learned to adjust my dies correctly, 'cause I don't have any chambering problems (which is the only reason I can think of for the FCD). I always use the "thunk test" for my 45 ACP and 9MM, and adjust my dies if needed.

July 4, 2012, 04:31 PM	#18
mikld Senior Member Join Date: February 7, 2009 Location: Southern Oregon! Posts: 2,891	"If I am reloading ammunition that requires a post sizing die to chamber it, then I need to learn how to set up my dies correctly and make sure the components are within spec. I am not a high volume reloader so for me I have no need to post size, but I can see the need for a reloader that cannot check components do to the quantity. I have been reloading 45acp for over 20 yrs w/o a FCD never had a problem that a FCD would fix." I agree 100%. I guess I've learned to adjust my dies correctly, 'cause I don't have any chambering problems (which is the only reason I can think of for the FCD). I always use the "thunk test" for my 45 ACP and 9MM, and adjust my dies if needed. __________________ My Anchor is holding fast! I've learned how to stand on my own two knees...