View Single Post
Old June 15, 2013, 02:52 AM   #22
AirForce2
Member
 
Join Date: June 23, 2008
Posts: 38
My 2nd TCP

Bought another TCP in blue finish since it was on $199 at sportsmans just to have another one since my stainless TCP carry one with my feed ramp job and a few mods thought another would be good to keep in the cookie jar.

Well this one sure was cut different than my first one. This one would even remotely feed the buffalo bore HP's or flat points right out of the box. I couldn't even hand cycle fast or hit the slide. This one needed a "major" feed ramp recut & polish just to hand cycle somewhat. Must have been some tweek on the machine cutter or something. Like a box of chocolates.
AirForce2 is offline  
 
Page generated in 0.02478 seconds with 8 queries