View Single Post
Old February 21, 2012, 08:00 PM   #4
Newton24b
Junior member
 
Join Date: February 10, 2009
Posts: 974
from everything ive seen on the uberti website and from bennelli customer service over the last few years, their is absolutely no difference in the actual frames between the "converted" revolver and the regular percussion models. only difference is they had to ad a washer between recoil shield and the rear of teh cylinder.

you CAN make a conversion cylinder at home, but youll need minimal tools. basic setup would cost you 1500 on the low end if you get cutting tools that are just good enough to get through one cutting job.
Newton24b is offline  
 
Page generated in 0.03485 seconds with 8 queries