Thread: 22 Ppc
View Single Post
Old November 14, 2002, 09:26 PM   #8
bfoster
Senior Member
 
Join Date: October 13, 1998
Location: N. of Fords Switch, OK, USA
Posts: 297
rjoy,

You can ream the flash holes out to fit the decapping pin of the die you purchase, or you can sand/stone/grind the decapping pin down to freely enter the flash holes of 220 Russian brass. I chose the later course and have had no problems. Ditto the flash hole deburring tool, though this brass usually has really minimal burrs.

Bob
bfoster is offline  
 
Page generated in 0.02941 seconds with 8 queries