The Firing Line Forums - View Single Post - Bullet lube in dies

Leftoverdj · April 28, 2006, 01:15 PM

Rodney, for most bottleneck rifle dies, make sure you clean out the vent hole in the shoulder. Welder's tip cleaners are good for this, but wire the right diameter works.

I use Simple Green as a solvent. Non toxic and non flammable.

April 28, 2006, 01:15 PM	#5
Leftoverdj Senior Member Join Date: October 15, 2004 Posts: 934	Rodney, for most bottleneck rifle dies, make sure you clean out the vent hole in the shoulder. Welder's tip cleaners are good for this, but wire the right diameter works. I use Simple Green as a solvent. Non toxic and non flammable.