View Single Post
Old September 4, 2005, 07:31 PM   #1
tomf52
Member
 
Join Date: August 5, 2005
Posts: 46
Lee Factory Crimp Die Question

Hello all. I'm back again with another crimp die question. My Redding die (Profile Crimp) is back at the factory awaiting an analysis by them if it's good or bad (posted question on this board last week). Meanwhile while browsing the net and some catalogs, came upon the Lee Factory Crimp Die and wonder if that would be a better tool to use. Any opinions out there as to how well they do or do not work or any other thoughts on the subject? Basically, I'm trying to reduce to a minimum the working of the case mouth by too much stretching (expanding and crimping) and get a good crimp on the bullet at the same time.Thanks' Tom
tomf52 is offline  
 
Page generated in 0.02647 seconds with 8 queries