View Single Post
Old October 7, 2013, 07:47 AM   #2
dahermit
Senior Member
 
Join Date: October 28, 2006
Location: South Central Michigan...near
Posts: 6,501
Just like choosing a gun for carry, it is always a matter of compromises. If I wanted the very best results (clean primer pockets, bright clean inside of cases). I would choose to use stainless steel media and equipment...especially if I was a used-brass case seller. However, if I just wanted an easy fast job on my own cases, I would not want to go through the bother and expense associated with wet media.
In short, stainless steel pins = the best. Walnut/corn cob = good enough.
dahermit is offline  
 
Page generated in 0.03420 seconds with 8 queries