The Firing Line Forums - View Single Post

DAL · December 23, 1999, 08:13 PM

Unfortunately, I think it was my fault. The cases were dirty, but I did 'em anyway. I was under the impression that carbide is so hard it's difficult to hurt it. Much to my chagrin, I found out differently. Oh well, live and learn. I'll order a new resizing die in a few days; I still have a set of .357 Mag. dies that I can use the resizing die from, but I'll order another .38 Spl. resizer anyway.
DAL

------------------
Reading "Capitalism: The Unknown Ideal," by Ayn Rand, should be required of every politician and in every high school.

December 23, 1999, 08:13 PM	#4
DAL Senior Member Join Date: October 15, 1999 Location: Colorado Springs, CO, USA Posts: 653	Unfortunately, I think it was my fault. The cases were dirty, but I did 'em anyway. I was under the impression that carbide is so hard it's difficult to hurt it. Much to my chagrin, I found out differently. Oh well, live and learn. I'll order a new resizing die in a few days; I still have a set of .357 Mag. dies that I can use the resizing die from, but I'll order another .38 Spl. resizer anyway. DAL ------------------ Reading "Capitalism: The Unknown Ideal," by Ayn Rand, should be required of every politician and in every high school.