The Firing Line Forums - View Single Post

Zhillsauditor · May 8, 2013, 01:47 PM

Drill them out using a bit slight bigger than the hole, to a depth just beyond the depth of the screw. Place a similar sized dowel in the hole with an epoxy (acraglas or devcon 2-ton). Allow a day to cure. Cot off any excess dowel protruding from the wood. Drill a new screwhole into the dowel, and you are ready to go.

Here's Midway USA's video http://youtu.be/dONmNF2i1hs

May 8, 2013, 01:47 PM	#2
Zhillsauditor Senior Member Join Date: October 19, 2008 Posts: 635	Drill them out using a bit slight bigger than the hole, to a depth just beyond the depth of the screw. Place a similar sized dowel in the hole with an epoxy (acraglas or devcon 2-ton). Allow a day to cure. Cot off any excess dowel protruding from the wood. Drill a new screwhole into the dowel, and you are ready to go. Here's Midway USA's video http://youtu.be/dONmNF2i1hs Last edited by Zhillsauditor; May 8, 2013 at 01:59 PM.