View Single Post
Old November 13, 2012, 08:49 PM   #19
res45
Senior Member
 
Join Date: September 15, 2007
Location: NC
Posts: 751
Quote:
Sounds good, as long as it doesn't affect reliability. I'd be open to any guidance as to how to do this for my AK (using a spare gas tube of course).
Never tried the mod on a AK but you can probably regulate the bolt speed and ejection pattern buy using cast bullets and a powder like 4895. Thats basically what I do with my Chinese SKS it cycles with a very low pressure curve only requiring 12.5 grs. of Alliant 2400 and a 170 gr. Lee gas check cast bullet drops the brass right at my feet,MV runs about 1450 fps. on the chrono.

Here is the thread http://www.sksboards.com/smf/index.php?topic=41391.0 If you PM Mr. Gibson he will probably provide you with some photos of the mods.

Last edited by res45; November 13, 2012 at 08:58 PM.
res45 is offline  
 
Page generated in 0.03604 seconds with 8 queries