|
Polishing a feed ramp
I have a Neos that has a little feeding issue with HP bulk ammo. Failure 1 out of 10. Feed ramp is rough with a little lip in the entry into the chamber. I used a half round needle file to knock down the lip with limitted improvement. The needle file didnt leeve a polished smooth edge and I would like to improve on it. Thinking of using a die grinder with a cratex cone wheel.
http://www.newmantools.com/cratex/index.html
I would like to know what you guys use.
__________________
Concentrated power is not rendered harmless by the good intentions of those who create it.
Milton Freidman
"If you find yourself in a fair fight,,,
Your tactics suck"- Unknown
|