MT, with my spring idea how would this work ?
say i remove the spring and follow your idea as per the above photo, i presume you are suggesting moving the shaft/rod, back and forth with the drill motor attached ?
sounds like a great idea, i'll experiment with it along with ricklaut's suggestion.
i am in the process of pulling bullets from nearly 2,000 rounds of a tried and true load the cases got mixed up with trimmed cases, i have a Dillon XL650, thus, i cranked out a lot of ammo in a short time, when i reload those cases, i plan on using the new Hodgdon CFR 223, the accuracy of that ammo is horrible, some will not even chamber due to the length of the case.
|