The Firing Line Forums - View Single Post - Suggestions needed for 1911 frame rail cutting

jp27 · May 27, 2001, 08:09 PM

George Stringer, If the information about having rails cut
on the 1911 forgings by a machinist or smith are correct as
stated by the ATF, I would pay someone to do this for me.
I understand that the work must be done at my direction.
[email protected]

May 27, 2001, 08:09 PM	#21
jp27 Junior Member Join Date: May 27, 2001 Posts: 8	Suggestions needed for 1911 frame rail cutting George Stringer, If the information about having rails cut on the 1911 forgings by a machinist or smith are correct as stated by the ATF, I would pay someone to do this for me. I understand that the work must be done at my direction. [email protected]