View Single Post
Old July 6, 2013, 12:30 AM   #1
AL45
Senior Member
 
Join Date: December 12, 2012
Posts: 753
Smoothing a rough extractor

The extractor on my Carcano bolt is marring the rim on the brass. It ejects the case fine, but there are marks on all the rims and all the area that engages the rim looks rough. How is the best way to smooth these tight areas up? I was thinking of a thin Dremel buffing wheel and jeweler's rouge or a thin smooth stone. Any ideas?
AL45 is offline  
 
Page generated in 0.03180 seconds with 8 queries