The Firing Line Forums - View Single Post - Low Cost Improve Reliability for 1911 Colt Commander

Sarge · February 1, 2013, 11:24 AM

1. Check ejector. If it's solid, flush with the frame and don't have a chipped or peened front edge, it's probably OK.

2. Check extractor for proper tension and hook configuration. If in doubt, replace it with an Ed Brown unit.
A good summary here: http://www.m1911.org/technic2.htm

*

3. I also like to fit an oversize firing pin stop plate, to prevent the extractor from rotating during function.

4. Eliminate magazine as source of problem. I've become so impressed with the Chip McCormick Power Mag that I now use them to the exclusion of everything else; but if all else is well, your Wilson should run just fine.

FWIW I have found the genuine 4 1/4" Commanders to be every bit as reliable as the fullsize guns, when set up properly.

* Photo credited to 1911 Tuner who, with any luck, will chime in here directly.

February 1, 2013, 11:24 AM	#19
Sarge Senior Member Join Date: May 12, 2002 Location: MO Posts: 5,457	1. Check ejector. If it's solid, flush with the frame and don't have a chipped or peened front edge, it's probably OK. 2. Check extractor for proper tension and hook configuration. If in doubt, replace it with an Ed Brown unit. A good summary here: http://www.m1911.org/technic2.htm * 3. I also like to fit an oversize firing pin stop plate, to prevent the extractor from rotating during function. 4. Eliminate magazine as source of problem. I've become so impressed with the Chip McCormick Power Mag that I now use them to the exclusion of everything else; but if all else is well, your Wilson should run just fine. FWIW I have found the genuine 4 1/4" Commanders to be every bit as reliable as the fullsize guns, when set up properly. * Photo credited to 1911 Tuner who, with any luck, will chime in here directly. __________________ People were smarter before the Internet, or imbeciles were harder to notice.