View Single Post
Old December 23, 2010, 10:51 AM   #7
Ervin
Junior member
 
Join Date: October 9, 2009
Posts: 125
Good info fellas.

I got a small gas cylinder wobble problem with my Garand currently.
So before I fix this I cant expect my loads to do better.
I got 2in groupings my first day, but because of the 1mm wobble, some of those rds went an inch right.
I was hoping loc tite would be an easier fix, cause I have no clue how to peen the barrel.
But then again, how long can this loc tite stuff last...

Also, is it possible to reduce the trigger pull by cutting down on the hammer spring?
Ervin is offline  
 
Page generated in 0.03197 seconds with 8 queries