View Single Post
Old October 13, 2010, 02:10 PM   #8
guncrank
Senior Member
 
Join Date: July 15, 2006
Location: Fern Creek ,KY and Metro Louisville at large
Posts: 430
C you can soft solder on the ramp. I use the ribbon solder Brownells sells.
If you brought that to me to fix, I would but barreled action in my Foster jig and drill a spotting hole that the screw would fit into. Not tapped , just major diameter.
Clean blue off of barrel and bottom of shorty ramp
A twist of tie wire and a kittle flux and a piece of ribbon solder.
Propane torch and presto.
That how this Trinadad State Junior College graduate (84) would do it.
CEW
__________________
Republic Arms and Armaments
07
1-502-231-1118
Machine Shop and Finishing Services to the trade and public
guncrank is offline  
 
Page generated in 0.03542 seconds with 8 queries